Hello Friends,
I will explain step by step how to install a Plesk panel from scratch via Linode or another provider. The task is very simple.
Why Linode :
- Option to get multiple IPs.
- Over 250,000 existing customers.
- Ability to get service from 6 different locations.
- Hourly billing.
- All disks are SSD
- Operating system installation with one click
- Fast support systems
If you want to use Linode, you can purchase it from this link: Linode Vps
First, we select and set up our VPS via Linode.
Above, system requirements are available; you can choose and install whichever is more ideal for you. After selecting, click the Add this Linode! button. http://content.screencast.com/users/redobilisim/folders/Jing/media/ca0a0816-1822-488b-a9a6-73845cc93a09/2014-12-25_2246.png
After clicking the button, it will appear under the Linode tab in your panel as shown above.
http://content.screencast.com/users/redobilisim/folders/Jing/media/e95a2d0c-7e36-4194-84c7-ca3145f56243/2014-12-25_2247.png
When we click on linode790791/Dashboard, our VPS status will open as shown above. Since nothing is installed yet, it is currently idle. Now we need to install an operating system. To do this, we click on the Rebuild tab.
A window will appear as shown above, asking us to determine which operating system to install and our root password. After setting these, click the Rebuild button. I installed Centos 6.5.
It will start installing the operating system as shown above. This process takes an average of 1 minute.
When the installation is finished, we need to boot the server. It is currently off. Once we click the Boot button, our system will be started. To access the operating system via SSH, we click on the Remote Access link from the tab above.
As understood from the image above, a panel where we can make various IP settings appears. Here, Public IPs is the active IP address on our VPS. Currently, one is assigned. If we want more, we click the IP Add link and write why we need it and send the message. I usually say it is for SSL; they don’t cause any trouble.
PLESK INSTALLATION
After learning our IP address, we connect to the IP address using Putty (for Windows users). http://content.screencast.com/users/redobilisim/folders/Jing/media/38ed32e2-7d62-40cc-abad-a0ed7103e325/2014-12-25_2252.png
Login as: Root, and then type the password we specified while installing the operating system and press enter.
First, we change the hostname.
hostname plesk.domain.com you can determine this according to your own preference.
We update the operating system. yum upgrade -y This process may take 1-2 minutes.
We install GCC. yum install gcc -y
After doing these, we can proceed to install Plesk.
Yes, as shown above, just writing the link below will be sufficient for the installation of Plesk.
wget -O - http://autoinstall.plesk.com/one-click-installer | sh
When this process is finished, our Plesk panel will be installed. (Approximately 10 mins)
To access the Plesk Panel, we can access it via ** http://IP ADDRESS:8880 **. At startup, the Username and Password are the same as the credentials we use for SSH.
Good luck
Yukarıdaki anlatım yeni başlayanlar için belki geçerli olmaya bilir. Bu tarz hizmetler Self Managed oluyor. Yani sana ait herşey. Fakat bir yerden başlamak gerekiyor öğrenmek için. Linode çok kullanışlı bu yönden , ben bazı denemeler içinde kullanıyorum sistem göçtügü an hemen yenisini kuruyorum 
